Shopping cart
$0.00

RC model Bugatti 35

Print by separate parts, not everything at once.

You will need:

  • bearing 15x10x4 – 8ks h
  • Servo JX servo 6221MG – 1x (or similar, power 8kg)
  • engine – 35 T (coil)
  • regulator -180 A max , 11,V h
  • Baterry LiPo 3cell 11,1V – dimensions: 85x40x25mm (space for battery)

A few words about the building …..

Read the whole manual before construction

I leave the material to the customer’s choice i use PLA for all.
Choose a material best for your printer and has beautiful layers.
I recommend a layer of 0.2 mm, just 20% fill. For bearings use and caradans use min 75% infill.

For tires 5%
But if your printers combine layers, take advantage of it. Alternatively, if you want a very detailed surface, print on a 0.1 mm layer.

Manuals

Comments

  • Wietze Plantinga ,

    I have printed the parts and assembled the car without RC control. I found some parts hard to print (steering wheel for example. Also a lot of glue is needed to build the structure. The build guide is minimal.
    But I like the shape of the car and enjoyed the printing and assembling process.

  • Leave a Comment

    Your email address will not be published. Required fields are marked *

    Leave the field below empty!

    Previous reading
    RC model Delage 15 S8
    Next reading
    RC model Tatra 75