Shakra Mask and Bracers
This is a digital 3D printable model of the Shakra Mask and Bracelets from Silksong.
📦 Included Files
- 3MF print-ready presupported file
All cut parts are placed on the print bed just as we would print them, saving you time.
- Mask: 240 × 330 × 420 mm (9.4 × 13 × 16.5 in)
- Bracelet: 150 × 170 × 90 mm (5.9 × 6.7 × 3.5 in)
Settings may vary depending on your printer, so treat these as a starting point.
You will need glue, black wire (max 1.8 mm wide), a stretch band, 4pcs 10×3 mm neodymium magnets, and optionally white pantyhose and padding.
Mask
• There are two versions of Part 01 — with and without the visor. Make sure to choose the one you prefer.
• If you're using the version with visor holes, we recommend covering the mask with white pantyhose before inserting the eyes.
• Use the included pins and glue the parts together.
• Glue the eyes into the holes; you can bend them using hot water or a heat gun, but it’s not necessary.
• For the antennas, insert black wire or filament (max 1.8 mm) and secure it with tape.
• Use a stretch band to wear the mask. For comfort, consider adding padding inside.
Note: Pins for the Mask and Bracelet are different!
Bracelet
• For best wearability, use 10×3 mm magnets — this allows the bracelet to open and close easily.
• Glue the included pins only to one side of the bracelet.
• Insert magnets into both sides. Be careful to match the correct polarity.
• Magnets hold the bracelet together, and the pins keep the parts aligned.
No 3D printer? No problem! Search for your local 3D printing services.
This fan-made model was brought to life by 3Demon, a team of modeling and 3D printing enthusiasts based in Prague, Czech Republic. We’ve been creating 3D printable models for over a decade, from cosplay accessories to all sorts of interesting designs.
✨ Check out more of our creations or join our community here.