Description
Digital 3D printable model of a cute Halloween bat. The model is a flying mobile – a toy that flaps its wings.
ASSEMBLY
- Apply pressure to the wings to free the hinges
- Connect the ears, yellow eyes and body using a little glue.
- Cut two pieces of fishing line of the same length. I used 2 x 90 cm.
- Run the fishing line through the holes in the wings from the bottom and then through the hole in the bar above. Tie a knot at the top and tuck the ends of the knot into the side slit.
- Repeat on the other side.
- Then just tie the bead to the hole in the belly of the bat using another piece of fishing line.
3D PRINTER SETTINGS
- Use supports on the head and ears
- 0.15 mm layer height
- 15% infill
- 3 mm brim
All cut parts are placed on the print bed as we would print them to save you time.
At 100% scale the largest part of the body is 180 mm wide on the build plate (full wingspan is wider).
This is a digital 3D printable model. Do you like the model and don’t have a 3D printer? There are lots of people who offer 3D printing services these days. Try searching for someone who offers them in your area.
This fan-made model was brought to life by 3Demon. We are a group of modeling and 3d printing enthusiasts based in Prague, Czech Republic. We’ve been making 3D printable models for more than a decade. We make a lot of cosplay accessories but we also make all sorts of interesting 3D models. You can join our community or just look at more of our creations here
Got something to discuss?